保定市博纳特机械设备制造有限公司
地址：河北省保定市保定●中关村创新中心
销售热线：17731262605
0312-3388656
办公室/传真：+86-312-8927651
技术部：+86-312-8927651
网址：www.hbbonate.com.cn
邮箱：BNT3388656@126.com
驱鸟器安装方法
[来源：原创] [作者：aywl] [日期：17-06-22] [浏览次数：3]
1、先将固定驱鸟器的U型底座安装到需要安装驱鸟器的导线横担上，如图所示： 1. Install the u-shaped base of the fixed drive device to the traverse of the wire that needs to be installed, as shown in the figure: 2、用扳手将U型底座的螺母拧紧，直到感觉螺母已经非常禁锢的安装到横担上。 2. Tighten the nut of the u-shaped base with a wrench until the feeling nut has been installed on the cross. 3、将驱鸟器底部的安装螺孔对准U型底座向上的螺杆，然后双手按照顺时针方向旋转驱鸟器至驱鸟器本体进入螺杆1.5—3厘米接近螺杆上的螺母的位置。注意此位置要对准太阳光照射最长时间的方向（太阳能板面向南方为佳）。 3, install QuDiao objects bottom of screw up the screw hole on the u-shaped base, and in accordance with the clockwise QuDiao apparatus to QuDiao device ontology into the screw 1.5 -- 3 cm close to the location of the screw on the nuts. Note that this position is aimed at the longest direction of sunlight exposure (solar panels are best for the south). 4、用扳手将驱鸟器底部螺杆上的螺母按照顺时针的方向拧紧，知道感觉驱鸟器已经紧固，不会被风吹或者其他的力量作用后，发生旋转的现象。 4, using a wrench to QuDiao on the bottom of the screw nut tighten according to clockwise direction, know the feeling QuDiao device has been fastening, not by the power of the wind or other function, the phenomenon of rotation occurs. 5、打开安装在驱鸟器右侧太阳能电池板下方的开关按钮，注意安装在开关附近的电源指示灯是否工作。（红色的指示灯不停的闪烁） 5. Open the switch button on the bottom of the solar panel installed on the right side of the orator, and notice whether the power indicator installed near the switch works. (red light keeps flashing)